Hair Clipper POWER UP 10W Integrated skin protection system

HOW TO USE

1. Oil the cutting blades before using the clipper for the first time.
2. Turn on the clipper by ON/OFF switch.
3. Please only use the correct oil, apply the oil to the blades after each time use.

HOW TO CHARGE THE CLIPPER

Before the equipment is used for the first time, it should be charged 3-5 hours. Plug the power cord directly into the unit. Make sure that the clipper is switched OFF when charging. During charging, the charge indicator is illuminated. The charge indicator will begin to blink when almost fully charged and may shut off when fully charged.

USING RECHARGEABLE CORD/CORDLESS CLIPPERS

This unit may be used without a cord when fully charged. If the battery power is low, a power cord can be attached directly to the unit to continue using the device as a corded unit. • Plug the power cord into a power outlet at the correct voltage. • Plug the power cord directly into the unit. Be sure the clipper is switched OFF when charging. • For corded operation, connect the cord to the receptacle located at the bottom of the unit. If the battery is completely down, allow the unit to charge for 1 minute (switched OFF) before using as a corded unit. • If the cord is left attached to the unit when not in use, the cord will automatically charge the unit when left in the OFF position.

HOW TO CHANGE THE BLADES

Switch off the clipper and disconnect it from the power outlet.

Undo both screws on the cutting set, remove the bottom blade and the top blade.

When assembling, the bottom blade and top blade should be aligned as follows:

1. Raise and adjust the cutting-length adjustment lever to the shortest cutting length.
2. The distance between the front edge of the bottom blade and the front edge of thetop blade should be between 0.8mm and 1.5mm.
3. The bottom blade and the top blade should be parallel to each other.
4. The first tooth of the top blade (from the left) must cover the first tooth of the bottom blade.
5. The outermost tooth of the top blade (on the right) must touch the outermost large tooth of the bottom blade (on the right).
6. Tighten both screws.

HOW TO ADJUST THE CUTTING-LENGTH:

1. Use the blade lever:

The cutting length can be easily adjusted even during operation. When the lever is in the uppermost position, the blades will give the closest cut. If you push the lever downward gradually, it will increase the cutting length.

2. Use the attachment comb:

Depending on the desired haircut, the clipper can be operated with or without an attachment comb.

Place the attachment comb onto the cutting edge of the cutting set and press it down onto the cutting set until it clicks into position.